OMEdit: improve drawing of connections by correctly initiated x/y mode

[Jan Kokert]

When a connection (e.g. from a resistor to a gnd) is drawn, OMEdit seems to have a default behavior that the first line is already fixed in vertical position and when clicking the first horizontal position is set by then forming a corner.
This is perfectly fine if the connectors of elements are oriented from left to right, which is the default orientation in MSL.

Users, of course, will turn e.g. resistors in a way, that the connectors are vertically aligned. Then the default line initialization orientation is a bit annoying.

I can imagine that it is a bit tricky for OMEdit (or the programmer :-P) to figure out, what the user actually mean. But what about the following:

Idea 1:
When starting a connection (by clicking and dragging) the user will already (roughly) point in the right direction e.g. 10 pixels up and 3 pixels left). By figuring out that amount and checking which is the most dominant one, the initial connection X/Y mode could be initiated properly.

Idea 2:
Another possibility is to update the x/y mode continuously until the first corner is set. So assume the start is at 0/0 and the mouse is at (10,3) then OMEdit is in y-fixed mode. If the mouse is moved (without clicking) to (10,23) then OMEdit switches to x-fixed mode.

Idea 3:
A further possibility is to allow manual switching of the mode by hitting the space bar. This is the default behavior in Eagle (a PCB layout program).

After this x and y mode is alternating.

I really hope that these ideas helps :D